Hi Tom,

   I am looking for a method of setting IPR feed rate.

   I can do this now with g32 in line segments, but I am unable to specify a feed per rev in acrs.

   I am controlling a lathe, and with CSS changing the rpm on the fly I need a method of feed rate control that keeps the two relatively in sync.

  Thanks,

   Andrew

Hi Andrew,

With an initial look it seems like adding the G Code, Feedrate mode, and testing it similar to:

    if (_setup.motion_mode == G_32)  // Threading?

might work.  Are you willing to test?  :)

Regards

TK

 

Hi Tom,

   I am looking for a method of setting IPR feed rate.

   I can do this now with g32 in line segments, but I am unable to specify a feed per rev in acrs.

   I am controlling a lathe, and with CSS changing the rpm on the fly I need a method of feed rate control that keeps the two relatively in sync.

  Thanks,

   Andrew